Simulation of Flash-Butt Welding Process of a Railway Steel. Part 1: Residual Stress Analysis Via FEM

Abstract

Long rails, welded by the Flash-Butt Welding (FBW) process, are the reality of the Brazilian railroads for medium and high axle loads. Although they present desirable characteristics concerning the dynamic behavior of the track, welded joints are regions of structural and mechanical discontinuity where high residual stresses originate, and, consequently, premature fatigue failures may take place. This paper employs the Finite Element Method (FEM) to carry out transient, physically non-linear thermo-mechanical analyses to evaluate residual stresses evolved in the welding process. A new approach is proposed to take into account the heat input involved in the process. The numerical results are compared to experimentally measured surface residual stresses, and to the macrographic joint aspects, including the HAZ width and cooling rate data. The results show a good correlation between the numerical and experimental measurements of residual stresses. Fundamental aspects related to the development of residual stresses are clarified, correlating numerical and experimental analyses. In addition, it is verified that the computational models can be used to predict critical crack nucleation points by fatigue, and/or to evaluate effects of process parameters on the residual stress field.

Key-words:
Flash-butt welding; The Finite Element Method; Welding metallurgy; Residuals stresses