Abstract
Objective:
This study aims to compare water and power consumption in four cycle configurations (number of pulses in the conditioning phase, drying time, and vacuum depth set point) for steam sterilization.
Methods:
A descriptive study of four different cycle configurations: In configuration A, conditioning phase vacuum pulses were set to a total of three, with a lower vacuum set point of 90 mbar and a higher pressure set point of 1500 mbar. The drying phase was set for 45 minutes with a vacuum level of 90 mbar. Water and power consumption were measured during the entire conditioning phase, and every 15 minutes during the drying phase. In configuration B the conditioning phase vacuum set point was adjusted to 150 mbar and the other parameters were identical to configuration A. On configurations C and D, the quantity of vacuum pulses was set to five, with higher pressure adjusted to 1500 mbar in both configurations. The lower vacuum set point was adjusted to 90 mbar in configuration C and to 150 mbar in configuration D.
Results:
Water consumption at the drying phase had the most impact on the total water consumption for the entire cycle.
Conclusion:
This study shows that increasing drying time to solve wet packs will increase water consumption, a scarce natural resource, and should be the last option to achieve dry loads at the end of the cycle.
Keywords
Steam; Sterilization; Water consumption; Natural resources; Equipment and supplies
